Many first technology Ford Explorers did not come geared up with overhead consoles. The Overhead Console accommodates lights and an additional storage unit which many individuals find useful. Putting in an Overhead Console on your Ford Explorer is slightly difficult as it includes wiring the lights to the vehicle, but for essentially the most half it is a pretty simple process, and you need to have the ability to set up the Overhead Console in approximately one hour.
Ford Explorer Overhead Console Installation Instructions
1. Turn the engine of the Explorer off and open the hood. Using a socket wrench, disconnect the negative terminal from the battery of the vehicle.
2. Open the door and sit in the driver’s seat. Place the mounting on the ceiling of the Explorer and trace it with some chalk.
3. Use a small knife to chop away on the higher portion of the Explorer. This will reveal two slots and two screw holes.
4. Snap the mounting bracket into the slots and insert two screws into the screw holes to secure it to the vehicle.
5. Remove the facet pillar from the right side of the vehicle. Run the wiring harness beneath the headliner down though the pillar.
6. Join the wiring harness to the electrical connectors. The pink wire connects to a blue wire, the black wire connects to a blue wire, the green wire goes with an orange wire, and one blue wire goes to a yellow wire while the opposite to a white wire. Lastly, the gray wire goes with black wire.
7. Reconnect the battery of the Explorer and check the overhead console. If every little thing is set up correctly, it ought to operate properly.
